In the end what kind of material is the stone protection agent, and how to do the best protection to deal with its effectiveness? Which stage of stone processing must be protected in order to meet its maximum economic efficiency Which kind of installation method can avoid a large number of lesions Infringement of stone stone industry is currently faced with the problem of stone maintenance, mostly due to the occurrence of lesions after installation. When all aspects seek the cause of stone problems, the focus is often on whether the stone installers used unqualified stone, whether the stone installers cut corners, and whether the stone construction method is appropriate. These are questions that everyone should pay attention to!

       At present, the most commonly used method in stone processing plants in China is to apply a layer of wax on the surface of the finished stone, which can increase the surface gloss of the finished stone products and reduce the chicken paw pattern on the surface of the stone. The wax is a surface protective material. When it covers the surface of the stone, the original capillary pores and fine lines on the surface of the stone will be blocked. Therefore, if the stone installation company or the stone guardian wants to carry out the stone protection project, the wax already existing on the stone surface will instead It is the biggest obstacle inside the stone material that the protective agent penetrates the stone, which causes the protective layer to exist only on the surface and cannot penetrate below the surface of the stone. It may cause the protection failure and the risk of subsequent lesions to greatly increase. This is a problem for consumers and construction installers. It may cause great trouble. In this case, if the ground stone is paved with a soft-bottom wet construction method, the laid stone is often a less dense material (such as light-colored granite, etc. Almost impossible to avoid, in addition, many of the stone after waxing are exposed to the air and sunlight for a long time, which is prone to yellowing, and may be the primary factor in the yellowing of the stone.

        In fact, from a chemical point of view, except for the wax engineering failure rate may be higher than the probability of success, this can be used as a metaphor for doctors to carry out human poisoning first aid, we must clearly analyze the chemical composition of wax and remedy, and also need to take into account It is actually a difficult matter to injure the stone itself because it is not toxic. It is almost impossible to ask the stone protection industry to have a complete background of chemical education.

        For the above-mentioned problems (to be protected after the stone is waxed), currently some stone protection companies will use the wax removal process to clean the surface of the stone, but the effect is often not as good as expected, mainly because the wax may be removed. The agent does not work well. There are too many kinds of waxes, which are currently applied to the waxes on the surface of building materials. There are no less than dozens of types of resins, acrylics, silicons, etc., and non-resinous acetic acids, Olen acids, ash, etc. The nature and physical properties are not the same. Therefore, it is not easy to find a wax remover that can be applied to each wax.